Emerson XEV22D Specifikace Strana 28
- Strana / 36
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
22 • XEV22D I&O Manual 026-1206 Rev 3 13-DEC-2012
19 ECT MODBUS
Networking to
E2s
19.1.COM Port Associations
- E2 Versions 3.xx and
Below
Connecting an XEV22D controller to an E2 re-
quires the E2 to be version 2.84 or above. Contact Re-
tail Solutions for upgrade information if the controller
is a version before 2.84.
An E2 has up to three COM ports that can be as-
signed for MODBUS communication: COM2, an
RS485 port on the E2 power interface board, and
COM4 and COM6, which are optional ports requiring
expansion cards.
COM4 is recommended for MOD-
BUS connection of Emerson units.
Connect the MODBUS network cable to the three-
terminal connector on the COM port you wish to as-
sign as MODBUS. Reverse polarity of +/- on RS485
cable from E2 to the device.
COM ports can only be used for one function; in
other words, if COM2 is set up as the I/O network,
you cannot connect MODBUS devices to COM2. En-
sure your E2 is equipped with an RS485 COM Card
(P/N 637-4890) and configured in E2 General Servic-
es (, Serial tab) to enable COM4 or an
E2 Expansion COM Card (P/N 637-4871) to enable
COM6.
Connect the MODBUS network cable to the three-
terminal connector on the COM port you wish to as-
sign as MODBUS. Reverse polarity of +/- on RS485
cable from E2 to the device.
Figure 19-1 - Location of E2 COM Ports (E2 Versions 3.xx and
Below)
Figure 19-2 - MODBUS Networking
- XEV22D Driver for Stepper 1
- Kennesaw, GA 30144, USA 3
- Phone: 770-425-2724 3
- Fax: 770-425-9319 3
- Table of Contents 5
- 1 Introduction 7
- 2 Overview 7
- 3 Wiring Connections 8
- 4 Wiring Guidelines 9
- 5 Mounting and 10
- Powering 10
- 5.2.2. XEV22D Power Wiring 11
- 5.2.3. Wire Type and Maximum 11
- Distances 11
- 7 Absolute 14
- Maximum Power 14
- 8 Front Panel 15
- 9 User Interface 16
- 9.7. How to Assign a 17
- MODBUS Address 17
- 10 Parameters 18
- 11 Digital Inputs 23
- 12 Forced Opening 23
- 13 Electrical 23
- Connections 23
- 14 RS485 Serial Line 23
- 15 How to Use the 24
- 16 Display Messages 25
- 17 Specifications 26
- 18 E2 MODBUS Network Wiring 27
- 19 ECT MODBUS 28
- Networking to 28
- 19.2.COM Port Associations 29
- - E2 Versions 4.2 and 29
- 19.3.E2 Setup of Devices 29
- 19.4.Wiring Types 31
- 19.5.MODBUS Termination 31
- 20 Standard Values 32
Vivitek Projectors user manuals
Starting on H
Komentáře k této Příručce