
How to Program a Hot Key From the Controller (Upload) How to Use the Hot Key • 15
13 How to Use the
Hot Key
13.1.How to Program a Hot
Key From the
Controller (Upload)
1. Program one controller using the front keypad.
2. When the controller is ON, insert the Hot Key and
press the UP arrow key; the uPL message will ap-
pear followed by a flashing End LED.
3. Push the SET key and the End LED will stop flash-
ing.
4. Turn OFF the controller, remove the Hot Key, then
turn it ON again.
13.2.How to Program the
Controller Using a Hot
Key (Download)
1. Turn OFF the controller.
2. Insert a programmed Hot Key into the 5-pin con-
nector and then turn the controller ON.
3. Automatically the parameter list of the Hot Key is
downloaded into the controller memory, the doL
message will blink followed by a flashing End
LED.
4. After 10 seconds, the controller will restart work
with the new parameters.
5. Remove the Hot Key.
NOTE: The Err message is displayed in case
an error or failure in programming occurs. In
this case, push the UP arrow key again if you
want to restart the upload or remove the Hot
Key to abort the operation.
NOTE: The Err message is displayed in case
an error or failure in programming occurs. In
this case, turn the unit OFF and then ON if
you want to restart the download or remove the
Hot Key to abort the operation.
Komentáře k této Příručce