Emerson FM-3 Instalační manuál stáhnout pdf (Strana 151)

137

Quick Start

Figure 58: User Units View

Now setup the parameters in the Distance group on the User Units view. The Tab key is used

to easily jump through the available parameters. After entering data in a field, press the Tab

key to move to the next parameter. The parameters you must fill out are as follows:

Units Name – Enter the character string you wish to use for your distance units.

Decimal Places – Enter the number of digits after the decimal place you wish to use in all

distance parameters throughout the software (i.e. index distances/positions, PLS On/Off

points). Use the spinner window Up/down buttons to increase or decrease the number of

digits.

Distance Units Scaling – Enter the number of User Units the motor/load travels for each

revolution of the motor. You must enter the numerator and the denominator for this scaling

factor.

Master Units View

Use this view if you wish to set parameters for synchronized motion.

Position View

The Settings group on this view sets the Define Home Position.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 229 230

Žádné komentáře

Emerson FM-3 Instalační manuál Strana 151