Emerson Avocent Universal Management Gateway Uživatelská příručka Strana 18

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 146
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 17
12.....Avocent® Universal Management Gateway Appliance Installer/User Guide
Rear of the Appliance
Number Description
1 Power supplies.
2 Power Indication LED.
3 GB2 (eth1) 10/100M/1G Ethernet port. Can be connected to a second network or used for failover.
4 Sensors
5
Autosensing ports. On the Avocent® Universal Management Gateway 4000 and 6000 appliances,
all ports are autosensing. On the Avocent® Universal Management Gateway 2000 appliance, the
eight ports on the left are autosensing and the other 32 are dedicated.
Connectors on the Appliance Rear
Connecting targets
Service processor
Use a UTP cable to connect a service processor to either an autosensing or a dedicated port on the
appliance. See Port configuration on page 50 for more information on how to set up service
processors.
Serial
Use a UTP cable and a DB-9 or DB-25 console adaptor, as needed, to connect a serial target to an
autosensing port on the appliance.
The appliance supports both the Avocent and Cisco
®
serial port pinout configuration. The port will
autosense the pinout.
To connect serial devices and PDUs:
Make sure the crossover cable used to connect a device has the same pinout type that is
configured in the software for the port (either Avocent or Cisco).
1. Make sure the devices to be connected are turned off.
Zobrazit stránku 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 145 146

Komentáře k této Příručce

Žádné komentáře