Emerson E2 Návod k obsluze stáhnout pdf (Strana 58)

7. Procedures to remove the head are the same as

for any other Discus® compressor.

8. Installation of the module will follow the removal

steps in reverse.

Replacement will be the reverse of these steps.

5.5 Serial Number Change after

Compressor Replacement

After the compressor has been changed out and the

Intelligent Store™ Discus® components are put back

in place, the E2 should be edited to reflect the new

compressor S/N, and perhaps the model number that

is appropriate. See later comments (section 5.7)

regarding the Event Counters.

NOTE: The module and E2 don’t require proper

model numbers, EXCEPT for proper operation of

unloaders. Even if the stages are properly set up and

defined, the E2 will not control unloaders unless a

modulated model number is used. This is only

important if you have added (field up-grade)

modulation equipment to an existing compressor, or

perhaps installed a different compressor that now has

modulation.

Example:

Original compressor on rack 3DS3A100E-TFD

Modulation head added, 3DR3A100E-TFD

new model number

Access the appropriate E2 screens as shown on this

page.

To change the model or serial number after installing

a new compressor, access the ISD Summary Screen

(figure 5.9) on the E2:

1. Press menu to open the Main Menu.

2. Press 5 (Configured Applications).

3. Press 35 (ISD Compressor).

Figure 5.9 ISD Compressor Screen

Select the compressor that you wish to rename and

Press F5 (Setup). The ISD Compressor Screen

should be displayed as shown in figure 5.10. Key in

the desired text for the new serial number, or perhaps

model. Additional information for this compressor

may be entered in the category for Long Name.

Figure 5.10 ISD Setup Screen

AE8-1337 R1

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 70 71

Komentáře k této Příručce

Žádné komentáře

Emerson E2 Návod k obsluze Strana 58

Komentáře k této Příručce

Související produkty a manuály pro Dálková ovládání Emerson E2