Emerson MICRO MOTION 2700 Instalační manuál stáhnout pdf (Strana 19)

Transmitter Configuration and Use: Series 1000 and 2000 Transmitters 9

Using the Transmitter Display continued

Using the Display Using the CommunicatorUsing ProLink IIBefore You Begin

2.4.2 Display password

Some of the display functions, such as the off-line menu and resetting totalizers, can be protected by a

password. For information about enabling and setting the password, refer to Section 8.14.

Note: If the petroleum measurement application is enabled on your transmitter, an off-line password

is always required to start, stop, or reset a totalizer, even if the display off-line password parameter is

disabled.

If a password is required, the word

CODE? appears at the top of the password screen. Enter the digits

of the password one at a time by using

Scroll to choose a number and Select to move to the next

digit.

If you encounter the display password screen but do not know the password, wait 60 seconds without

activating any of the display optical switches. The password screen will time out automatically and

you will be returned to the previous screen.

2.4.3 Entering milliamp and frequency range values with the display

If you are using the display to change transmitter settings, the display uses a standard format and

procedure for entering range values for either mA or frequency outputs.

Enter range and scale values in scientific notation according to the following format:

Example of range value format

The correct format for the number –810,000 is shown below:

To enter mA or frequency range values with the display:

Note: This procedure assumes that you are already at the correct point in the display menu to begin

entering the range values.

Scroll, if necessary, until the first space is either a minus sign (–) for a negative number or a

blank space for a positive number.

Select.

Scroll until the first digit is the correct number.

Select.

Scroll until the second digit is the correct number.

Select.

Scroll until the third digit is the correct number.

XXXESY

Sign

For positive numbers,

leave this space

blank. For negative

numbers, enter a

dash (–).

Digits

Enter a four-digit

number; three digits

must fall to the right

of the decimal point.

Indicates

exponents.

Sign

Exponent

Enter the

power of 10 by

which the

digits will be

multiplied.

–8.100E 5

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 263 264

Komentáře k této Příručce

Žádné komentáře

Emerson MICRO MOTION 2700 Instalační manuál Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Emerson MICRO MOTION 2700