Emerson MICRO MOTION 2700 Instalační manuál stáhnout pdf (Strana 39)

Transmitter Configuration and Use: Series 1000 and 2000 Transmitters 29

Required Configuration Optional ConfigurationUsing the TransmitterFlowmeter Startup

Chapter 5

Flowmeter Startup

5.1 Overview

This chapter describes the procedures you should perform the first time you start the flowmeter. You

do not need to use these procedures every time you cycle power to the flowmeter.

The following procedures are discussed:

• Applying power to the flowmeter (see Section 5.2)

• Zeroing the flowmeter (see Section 5.5)

• Performing a loop test on the transmitter outputs (see Section 5.3)

• Trimming the mA outputs (see Section 5.4)

Figure 5-1 provides an overview of the flowmeter startup procedures.

Figure 5-1 Startup procedures

Note: All ProLink II procedures provided in this chapter assume that your computer is already

connected to the transmitter and you have established communication. All ProLink II procedures also

assume that you are complying with all applicable safety requirements. See Chapter 3 for more

information.

Note: If you are using AMS, the AMS interface will be similar to the ProLink II interface described in

this chapter.

Note: All Communicator procedures provided in this chapter assume that you are starting from the

“Online” menu. See Chapter 4 for more information.

Finish

Start

Apply power

Perform a

loop test

Tr i m m A

outputs (if

necessary)

Zero the

flowmeter

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 263 264

Žádné komentáře

Emerson MICRO MOTION 2700 Instalační manuál Strana 39